Shure Incorporated Table of Contents Replacement Parts TH53TwinPlex™ Omnidirectional Headset Threaded Mount Instructions General Description Wiring and Termination Features Typical Wiring Table Model Variations Key Converting LEMO to TA4F Care and Maintenance TA5F Wiring for Lectrosonics Bodypacks (Servo Biased Wiring)
General Description ™ The Shure TwinPlex omnidirectional headset offers exceptional sound quality and the lightest, most comfortable fit for a vari ety of applications. The TwinPlex dual-diaphragm technology yields extraordinary, off-axis response, and low self-noise while delivering life-like, exceptional clarity and robust low frequency response, free of digital interference. The cable itself is ultra quiet and has been tested to be the longest-lasting, most dependable cable in its class.
Shure Incorporated ◦ Headset frame can adjust down to the smallest child's head • High RF immunity for use with today's digital wireless systems • Paintable cables allow for discreet placement in professional theater applications • Interchangeable frequency response caps offer adjustable flat or presence responses •...
Shure Incorporated ➄ Select flat or presence Reversing the Boom The microphone boom can be positioned on the left or right side of the head. Unscrew the clutch to loosen the boom arm. Push down and snap out the boom arm.
Shure Incorporated Wiring and Termination Typical Wiring Table Re Cable Electri place Con Polari For Use Series cal De ment Wiring Line Art (From Solder Side) struc With sign Con tion nector 1.6mm cable Posi with 2 Red wire: Bias(2) tive con...
Shure Incorporated Converting LEMO to TA4F Re Cable Electri place Con Polari For Use Series cal De ment Wiring Line Art (From Solder Side) struc With sign Con tion nector Shield wire: Ground(1) 1.6mm cable Red wire: Audio/ Nega with 2...
Notes: • When using TwinPlex mics with Sony Hirose 4pin bodypacks, Shure recommends purchasing Shure –MTQG versions and not –NC versions. This facilitates an easier termination due to the lack of circuitry required in Shure 3wire/MTQG TA4F products. • Due to the thin cable on TwinPlex and the large boot on Hirose connectors, heat shrink may be required to build up the ca...
Shure Incorporated MTQG Connector Assembly Exploded View Note: Make sure to solder the shield to ground collar. Assembled View Specifications All specification values are based on using a typical bodypack with 5 V bias input or the RPM400MTQG preamplifier. When using the RPM400LEMO amplifier, refer to the RPM400LEMO specifications.
Page 15
Shure Incorporated Self-Noise, A-Weighted, Equivalent Acoustical 24.5 dB SPLA Signal-To-Noise Ratio 69.5 dB Output Clipping Level 3.0 dBV,1 kHz at 1% THD, typical Maximum SPL 142.0 dB SPL,1 kHz at 1% THD, typical Dynamic Range 117.5 dB typical Microphone Current Draw 120 to 240 µA, typical...
Shure Incorporated S/N ratio is the difference between 94 dB SPL and equivalent SPL of self noise, A-weighted THD of microphone preamplifier when applied input signal level is equivalent to cartridge output at specified SPL Dimensions Cable Cable Diame Microphone...
Shure Incorporated Certifications This product meets the Essential Requirements of all relevant European directives and is eligible for CE marking. The CE Declaration of Conformity can be obtained from: www.shure.com/europe/compliance Authorized European representative: Shure Europe GmbH Headquarters Europe, Middle East & Africa Department: EMEA Approval Jakob-Dieffenbacher-Str.