Troubleshooting - Sony Trinitron KV-XG29 Operating Instructions Manual

Troubleshooting

If you find any problem while viewing your TV, please check the following guide. If
any problem persists, contact your Sony dealer .
Symptom Possible cause
• Connection is loose or
Snowy picture
the cable is damaged.
• Channel presetting is
inappropriate or
incomplete.
Noisy sound
• The antenna type is
inappropriate.
• The antenna direction
is inappropriate.
• Signal transmission is
low.
• Broadcast signals are
Distorted picture
too strong.
Noisy sound
• The TV system setting
Good picture
or channel presetting
is inappropriate or
incomplete.
Noisy sound
• The selected sound is
inappropriate.
No picture
• The power cord,
antenna or VCR is not
connected.
• The TV is not turned
on.
No sound
Solutions
• Check the antenna cable and connection
on the TV, VCR and on the wall.
• Press SELECT until "MANUAL
PROGRAM" appears on the screen, then
preset the channel again.
• Check the antenna type (VHF/UHF).
Contact a Sony dealer for advice.
• Adjust the antenna direction. Contact a
Sony dealer for advice.
• Try using a booster.
• Turn off or disconnect the booster if it is
in use.
• If the sound of all the channels are noisy,
check the TV system (TV SYS) setting,
then press AUTO PROGR to preset the
channels again.
• If the sound of some channels are noisy,
select the channel, then select the
appropriate TV system (TV SYS).
• If the sound of some channels are noisy,
select the channels, then press A/B to
select the main sound (KV-XG29M90
only).
• Check the power cord, antenna and the
VCR connections.
• Press u (power).
• Press U (main power) on the TV to turn
off the TV for about five seconds, then
turn it on again.
Page
4
9
–
–
–
–
8
9
18
4
12
11
continued
Additional Information
21