Base Station; Srm-Flex Connect™ App; Srm-Flex: Rear Panel Features; Power Connection - Mackie SRM-Flex Owner's Manual

Base Station

Before even plugging the SRM-Flex in and turning
it on, the high frequency driver column needs to be
connected to the base station / subwoofer. This can
be done with or without the height extension modules
(aka spacers).
If the high frequency driver column
is not attached, the SRM-Flex will not
sound great. At all. This is because only
the subwoofer is being used.
To help determine how many height extension
modules are needed (if any), check out the venue
and compare it to where people will be in relation
to the SRM-Flex. Placement is important and more
information may be found on page 17. Please determine
that information before attaching any height extension
modules.
On the top of the base station / subwoofer (near
the grille) is a square opening. This opening is where
to place the height extension modules and/or high
frequency driver column.
The height extension modules contain Molex-type
connectors on both the top and bottom, indicating that
the assembly is not yet complete. The front of the high
frequency driver column contains a Running Man logo
on the front and the top is capped. The high frequency
driver column should be the last piece connected
to SRM-Flex.
Bottom Connector
Top Connector
Connection is simple. There is only one way
the height extension modules and high frequency
driver column fit into each other and the SRM-Flex's
base station / subwoofer: bottom into top (see
drawings on the bottom-left) with the grille(s)
facing the same way as the grille of the base station /
subwoofer. The back side of the height extension
modules and high frequency driver column are
flat black (no grille) with holes leading to screws.
Do not remove these (or any) screws.
You will void the warranty if you do!
SRM-Flex Connect™ App
SRM-Flex is designed to be used in conjunction with
the SRM-Flex Connect App. With it, all of the hardware
features listed here – and more! – may be controlled
remotely via Bluetooth connection. The only thing the
SRM-Flex Connect App can't do is turn the unit on and
off, select between mic/line or Hi-Z or pair a Bluetooth
device.
More information about the SRM-Flex Connect App
may be found by visiting the SRM-Flex Connect App
Reference Guide.

SRM-Flex: Rear Panel Features

1. Power Connection

This is a standard 3-prong IEC power connector.
Connect the detachable power cord (included in
the packaging) to the power receptacle, and plug
the other end of the power cord into an AC outlet.
Make sure that the AC power is matched
to the AC power indicated on the rear panel
(next to the IEC receptacle).
Disconnecting the plug's ground pin
is dangerous. Don't do it!
2

2. Power Switch

Press the top of this rocker switch inwards to turn
on the SRM-Flex. Press the bottom of this rocker
switch inwards to turn it off.
100-240VAC
50-60 Hz 110W
1
Owner's Manual
9