Assembly & Initial Set-Up Instructions - NorthStar ProShot Series Owner's Manual

Assembly & Initial Set-Up Instructions – REV. D
• Unpacking & Delivery Inspection
• Ladder Rack to Trailer Assembly Instruction
Each of these steps will be discussed in detail below:
Find and separate the components identified in Fig. 06251 and Fig.06546 – Hardware Bag. Inspect the pressure washer immediately after you
receive delivery for missing parts and damage.
If you have missing or damaged components, contact Product Support at 1-800-969-7073.
Pressure Washer Spray Gun – Qty. 2
Spray Gun – Part #796731
(Located strapped to the back of the Roll Cage)
STEPS FOR ASSEMBLY / INITIAL SET-UP
STEP 1. UNPACKING & DELIVERY INSPECTION
Pressure Washer Trailer
Lance – Part #791279
Any Questions, Comments, Problems, or Parts Orders
Call NorthStar ProSHOT Product Support 1-800-969-7073
• Connecting Battery
• Initial Pump & Engine Preparation
Ladder Racks
Ref.#1
(1) Drivers Side Front, (1) Passenger Side Rear
Ref.#2
(1) Drivers Side Rear, (1) Passenger Side Front
(Located inside large cardboard box)
Hardware Bag
(Located inside the small cardboard box on top of
the battery compartment)
12 | P a g e