Table of Contents
Advertisement
Cardholder
The clear plastic cardholder holds paper, cards, and
envelopes close to the platen. The red horizontal
line toward the bottom of the cardhold er indicates
th e base of the typing line.
The red vertical line at the top center of the card-
holder shows the position of the next character to
be typed. Use the red vertical line on the card-
holder to realign characters.
To realign characters for a correction:
1.
Position the characters in the small vertical lines
at the top of the cardholder.
2.
Roll t he paper down to the horizontal line
t owa rd the bottom of the cardholder (see
photo).
3. Position you r paper so the bottom of each char-
acter rests just above the line, as shown.
23
Drawing Lines
Use the cardholder to help you draw lines.
To draw a vertical line:
1.
Place a pencil or ballpoint pen in the notch on
the t op of the ca rd holder.
2. Using the platen knobs or index key, roll up or
down the page. (You can also pull the line finder
forward, t hen use the platen knobs to roll up or
down the page . With the line fi nder forward,
the platen rolls freely. Retu rn the line finder t o its
original pos ition when you finish.)
To draw a horizontal li ne:
1.
Place a pencil or ballpoint pen in the notch on
t he cardholder.
2.
Using t he spacebar, move the ca rrier across
the page.
Impression Control
The impressi on control lever is located t o t he rig ht
of the type element. You can change t he impres-
sion contro l setting to adjust the striking force
of the element.
To change t he impression control setting :
Push the lever to the right and slide it forw ard or
backw ard to t he desired number. Do not force the
lever against the notches when you cha nge
settings.
Use the follow ing list as a guide for setting the
impression control:
1-3
=
offset masters
3
=
most typing
3-5
=
stencils and carbon sets
Hide quick links:
Advertisement
Table of Contents
