Yale 22116 User Manual

Yale 22116 Wireless Door Contact User Manual
The Door Contact monitors the opening/closing of specified devices (e.g. door or window). The Door Contact is fixed to the
monitored device frame with an actuating magnet fixed to the device. When the door or window opens, the magnet moves
away from the Door Contact, activating an internal magnetic switch causing the Door Contact to transmit an alarm signal to
the Central Panel. The device also has the capabilities of communicating signal problems along with low battery situations.
The Door Contact design consists of a cover and base. The cover contains all electronics and the base provides a means for
fixing the device. An enclosed PCB tamper switch provides tamper protection against unauthorized device opening and/or
removal.
 
P P a a r r t t s s I I d d e e n n t t i i f f i i c c a a t t i i o o n n
1. LED indicator a.k.a. Learn / Test button
Press the Test button to transmit learning code or enter test mode
for 3 min.
2. Mounting Holes
Used to fixed and screw the Door Contact directly onto the Door
Frame or Wall.
3. Tamper Switch
Provides tamper protection against unauthorized device opening
and/or removal from mounting surface.
4. Battery Insulator
5. Fixing Screw
Screw used to secure the top and bottom case of the Door Contact.

 I n t e r n a l S w i t c h a n d
I n t e r n a l S w i t c h a n d
Loosen the bottom fixing screw and remove the cover to reveal terminal as shown.
6 6 . . E E x x t t e e n n s s i i o o n Terminal n
In addition to the built-in magnet switch, an additional 2-pin dry
contact terminal is provided for an extension magnet switch or any
device with N.C. (Normally Closed) functionality.
7. Supervision Jumper Switch (JP2)
Jumper ON
- When the jumper is set as ON, the Supervision function is disabled. (Factory
Default)
Jumper OFF
- When the jumper is set as OFF, the Supervision function is enabled.
8. Internal Magnetic Switch Jumper Switch (JP3)
Jumper ON (Factory default)
- When the jumper is set as ON, the Internal Magnetic Switch is disabled.
Only the device connected to Extension Terminal will activate DC-15SL /
DCA-15SL
Jumper OFF:
- When the jumper is set as OFF, the Internal Magnetic Switch is enabled.
(Factory Default)


A A c c c c e e s s s s o o r r i i e e s s I I n n c c l l u u d d
a) 1 Magnet
b) 2 White Caps
c) 2 Screws
d) 2 Wall Plugs
e) 1 Magnet double-sided adhesive tape pad
f) 2 Magnet mounting screws
T e r m i n a l
T e r m i n a l
e e d d
White cap
1
White cap