Table of Contents
Advertisement
Feature
Parameter set list
Manual selection
Parameter sets include
Factory pre-configuration
OTA
Simultaneous OTA
Single OTA
Bookmarks
URL format
Security mechanism
OTA provisioning (if empty)
Interface (if empty)
Re-provisioning (Set 1 filled)
Interface (Set 1 filled)
Carrier reset/provisioning
SWIM
SWIM certificate
Additional provisioning
Preferred bearer customization
Email customization
Other applications/features
Technologies
WAP Forum OTA provisioning
Support in the T226 for WAP
Name
Startpage
IP settings:
CSD phone no., CSD Data rate, CSD dial type
GPRS APN, password request, allow calls, authentication, data
compression, header compression, quality of services
IP address, datamode (conn.less or oriented)
UserId and password
Security on/off
Show images on/off
Response timer
Yes, between Analog (V32) and Digital (V110)
WAP/CSD, WAP/GPRS (different sets)
WAP/CSD (possibility to lock a setting), WAP/GPRS
WAP/CSD, WAP/GPRS configuration possible
WAP/CSD, WAP/GPRS configuration possible
WAP/CSD, WAP/GPRS is not possible
Not empty by default
Underlined
Operator verification through a code, included in the OTA data. This
code is shown to the user who can choose installation or not.
An Install question is asked with the code, if available.
The user has to choose if a new WAP profile shall be created or an
existing profile shall be replaced.
As above
As above
Yes, but not if the set is pre-configured in the factory and locked.
Not used for provisioning.
The SWIM is only used for WAP security, both WTLS connections and
digital signatures.
Both client and trusted certificates can be used for WTLS connections
and digital signatures.
No new certificates can be stored and no old ones can be removed by the
terminal.
Yes
No
Yes, MMS
Yes
T226 White Paper
July 2003 (Rev C)
49
Advertisement
Table of Contents
