Table of Contents
Advertisement
PATCH Screen
11) Shooting a dimmer
* The shoot level is maintained even after the screen is switched.
* If a CH is patched to a dimmer that is being shot, the shoot level of the patched load is 0%.
> F2 (DIM) Dimmer name(s) @ Level
Example) Shoot dimmer 2S3 at 50%.
> DIM 2S3 @ 50
12) Switching off all the dimmers that are being shot
> F13 (ALLoff)
13) Setting NDM for dimmer(s)
* Dimmers with NDM set carry out non-dimming operations (on/off) rather than dimming operations.
* The curve data of profile curve pattern No. 27 (NDM) is used for NDM control.
> F2 (DIM) Dimmer name(s) = F15 (NDM) ↵
Example) Set 2S1 to NDM.
> DIM 2S1= NDM ↵
14) Resetting NDM for dimmer(s)
> F2 (DIM) Dimmer names(s) = F15 (NDM) RESET ↵
Example) Reset 2S1 to NDM.
> DIM 2S1= NDM RESET ↵
15) Setting the proportional level for dimmer(s)
* Set the upper limit value of the dimmer output level.
> F2 (DIM) Dimmer name(s) = F16 (Prop.@) Level ↵
Example) Set 2S1 at 35% of proportional level.
> DIM 2S1= Prop.@ 35 ↵
16) Resetting the proportional level for dimmer(s)
> F2 (DIM) Dimmer name(s) = F16 (Prop.@) RESET ↵
Example) Reset the proportional level for 2S1.
> DIM 2S1= Prop.@ RESET ↵
17) Changing the actual scenes and preset scenes
* Refer to the attached sheet "How to change scene numbers."
↵ ↵
21-5
Advertisement
Table of Contents
