Sony SLV-X9D/E Operating Instructions Manual page 31

4
• If you connect the STB using the
PLAY
OK
• If you connect the STB using the
5
Press M/m to highlight STB BRAND
NO. and press OK. Enter the
PLAY
appropriate number using the
programme number buttons, then
OK
press OK. Refer to the table on page
32 for Set-Top Box brand number.
1 2 3
Press MENU to exit the menu.
4 5 6
7 8 9
0
MENU
Notes
• If your VCR is connected to the STB by the aerial cable, enter the programme
number of the VCR corresponding to the channel where you have set up the STB
output in step 4.
• You cannot watch programmes from your STB on the TV while recording unless
you record a programme from your STB.
• It is recommended to connect your STB to the DECODER/LINE-3 IN connector.
• For some STB, in order to avoid any conflict between the STB controller and the
VCR remote commander, be careful not to point the remote commander towards
the STB and the VCR at the same time.
• If POWER SAVE is set to FULL, you cannot watch or record programmes from
your STB during standby mode. Set POWER SAVE in the OPTIONS-2 menu to
OFF or PARTIAL.
aerial cable:
Press M/m/, to select RF and
press OK.
Press M/m to highlight
PROGRAMME NO. and press
OK. Enter the appropriate number
using M/m and press OK.
Scart (EURO-AV) cable:
Press M/m/, to select LINE3 and
press OK.
SET-TOP BOX
STB CONNECTION RF
STB BRAND NO.
---
PROGRAMME NO.
06
RETURN
SELECT :
SET : OK
EXIT :
SET-TOP BOX
STB CONNECTION LINE3
STB BRAND NO. ---
RETURN
SELECT :
SET : OK
EXIT :
SET-TOP BOX
STB CONNECTION RF
STB BRAND NO. 123
PROGRAMME NO. 06
RETURN
SELECT :
SET : OK
EXIT :
continued
Setting the Set-Top Box
MENU
MENU
MENU
31