Table of Contents
Advertisement
4.11
M
4.11.1
mas-integration
Description
This command enables Mobility Access Switch integration on an AP.
Syntax
mas-integration
no...
Parameter
mas-integration
no...
Usage Guidelines
Use this command to integrate Mobility Access Switch with an AP.
You can integrate an AP with a Mobility Access Switch by connecting it directly to the switch
port. The following Mobility Access Switch integration features can be applied while
integrating with an AP:
● Rogue AP containment—When a rogue AP is detected by an AP, it sends the MAC
Address of the rogue AP to the Mobility Access Switch. The Mobility Access Switch
blacklists the MAC address of the rogue AP and turns off the PoE on the port.
● PoE prioritization— When an AP is connected directly into the Mobility Access Switch
port, the Mobility Access Switch port increases the PoE priority of the port. This is done
only if the PoE priority is set by default in the Mobility Access Switch.
Note
The PoE Prioritization and Rogue AP Containment features is available for ArubaOS 7.2
release on Aruba Mobility Access Switches
● GVRP Integration—Configuring GARP VLAN Registration Protocol (GVRP) enables the
switch to dynamically register or de-register VLAN information received from a GVRP
applicant such as an AP. GVRP also enables the switch to propagate the registered
VLAN information to the neighboring switches in the network.
Note
The associated static VLANs in the wired and wireless profiles are propagated to the
upstream Mobility Access Switch using GVRP messages.
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
Description
Enables you to integrate the AP with a Mobility Access Switch.
Removes the configuration.
CLI Commands
4.11 M
195
Advertisement
Table of Contents
