Pitney Bowes SendPro C Series Installation Instructions

SendPro C-Series
®
(C200, C300, C400)
1. CAUTION

Do not connect SendPro C to
a power source yet.
2. Unpack SendPro C.
Remove all packing materials
from SendPro C before
assembling them.
Groove Peg Tab
3d. Squeeze the tabs and
slide the printhead pegs
into the lower set of grooves.
3h. Close the cover.
Installation Instructions |


Be sure to grab the entire feeder,
not just the flap.
3. Install the printhead and ink cartridge.
3a. Open the cover to access
the ink carriage.
This step is critical to
prevent system damage.
3e. Keep squeezing the tabs and push
the printhead flush against the wall.
Tabs will snap outward when placed
correctly.
4. Connect SendPro C to a power source and continue installation steps.
4a. Connect SendPro C to a power source and turn on the power switch.
During installation you'll be prompted for a Scale Location Code. Find it on the reverse side.
pitneybowes.com/us/installsendprocseries
What's in the box
Printhead in
Ink cartridge Power cord
package
LAN/Internet
cable E-Z Seal Tape sheets
3b. Remove the packing tape from
the ink carriage, and open the
guard.
3f. Unwrap the ink cartridge and
make sure you remove the
silver foil strip from the ink
cartridge.
Scale
SendPro C
3c. Unwrap the printhead and
remove the protective strip.
3g. Install the ink cartridge
and close the guard.
4b. Wait for system startup...
Then tap "Get Started"
on the touchscreen and
continue installation steps.
