Installation Procedure - Sony HKSR-5803HQ Installation Manual

1-3. Installation Procedure

1. Turn off the power of the VTR.
2. Fully loosen the two fixing screws, and then slide the
two knobs on the upper lid (front) assembly each to the
inside. (Move the knobs to the outside to fix the upper
lid (front) assembly.)
3. Remove the upper lid (front) assembly in the arrow
direction.
Knob
Fixing screw
1-2 (E)
Upper lid (front) assembly
Knob
Removal
Installation
4. Fully loosen the two fixing screws, and then remove
the upper lid (rear) assembly in the arrow direction.
Fixing screw
Upper lid (rear)
assembly
Protrusion
Square hole
5. Raise the eject levers of the HPR-22 board in the
arrow direction, and then pull out the board slowly
upward.
Eject lever
HPR-22 board
Fixing screw
Eject lever
HKSR-5803SQ/5803HQ