D4. Check Brake Pads And Discs For Wear - Mitsubishi Pajero Sport 2013 Inspection And Maintenance Manual

D4. CHECK BRAKE PADS AND DISCS
FOR WEAR
<Front>
<Rear>
1. Check the brake pad thickness through the caliper
body check port.
Standard value:
9.5 mm <Front>
10.0 mm <Rear>
Limit:
1.5 mm <Front>
2.0 mm <Rear>
2. When the thickness is less than the limit, always
replace the pads at an axle set.
PERIODIC INSPECTION AND MAINTENANCE
OPERATIONS OUTSIDE THE VEHICLE
M6020500400767
AC801465AC
AC808013AB
3. Using a micrometer, measure disc thickness at
eight positions, approximately 45° apart and 10
mm in from the outer edge of the disc.
Standard value:
28.0 mm <Front>
18.0 mm <Rear>
Limit:
26.4 mm <Front>
16.4 mm <Rear>
4. If the disc thickness is less than the limits, replace
it with a new one.
BRAKE DISC RUN-OUT CHECK
1. Remove the brake assembly, and then hold it with
wire.
2. Temporarily install the disc with the hub nut.
3. Place a dial gauge approximately 5 mm from the
outer circumference of the brake disc, and
measure the run-out of the disc.
Limit:
0.06 mm <Front>
0.08 mm <Rear>
2-49
ACX00668AF
ACX00669AF