Transferring Jpeg Viewer To The Rm-Nx7000 - Sony RM-NX7000 Software Manual

Transferring JPEG VIEWER to the RM-NX7000

You need to download the latest kernel for the RM-NX7000 to your
computer to use JPEG VIEWER.
Consult the NAVITUS Web site (http://www.sony.com/nxremotesupport)
about how to download the kernel.
After downloading the latest kernel to your computer, use "NAVITUS
Design" to transfer it to the Remote Commander by connecting the Remote
Commander to the computer with the USB cable.
Before connecting the Remote Commander to the computer with the USB
cable, set the Remote Commander to the recovery mode.
Step 1: Set the Remote Commander to the RECOVERY
mode
Press the [SET] key for 2 seconds or longer in
1
the Home display.
The Set display appears.
2 Press the [SYSTEM] key.
The System display appears.
3 Press the [RECOVERY] key for 2 seconds or
longer.
The confirmation display for the transition to the recovery mode
appears.
Press the [YES] key.
4
After restarting, the Remote Commander enters the recovery mode.
Step 2: Connect
Connect your Remote Commander to your
1
computer with the USB cable.
Notes
• Before connecting the Remote Commander to your computer, be sure to
connect the supplied AC power adaptor to the Remote Commander.
• Do not disconnect the USB cable from your computer, until kernel transfer
and Remote Commander update are complete, as a malfunction may occur.
• Do not connect several Remote Commanders to your computer at the same
time, as you will not be able to transfer the kernel to the Remote
Commander. Connect only the RM-NX7000.
4