Sony RM-LJ312 Primary Operating Instructions Manual page 26

Switching the COMMAND
MODE
You can switch the command mode (AV
SYSTEM 1 or AV SYSTEM 2) of the remote. If
the command mode of the receiver and the
remote is different, you cannot use the remote to
operate the receiver.
Besides, you can set the remote for the 2nd zone
mode or 3rd zone mode (models of area code U,
CA only).
1
Press RM SET UP.
The set up list appears.
cIR SET
LEARNING
DOWNLOAD
INPUT LIST
2
Move the easy scroll key to select
"COMMAND MODE", then press the
key to enter the selection.
The COMMAND MODE list appears.
<COMMAND MODE>
cMAIN
2ND ZONE
3RD ZONE
*STR-DA5000ES and the initial setting only.
3
To select the command mode for the
main receiver
Move the easy scroll key to select "MAIN",
then press the key to enter the selection.
MAIN list appears.
<MAIN>
AV SYSTEM 1
cAV SYSTEM 2
Exit
Move the easy scroll key to select "AV
SYSTEM 1" or "AV SYSTEM 2", then
press the key to enter the selection.
To select the 2nd zone mode
(STR-DA5000ES only)
Using an optional IR repeater as shown on
page 27, the following operations are
possible with the remote:
• Switching sources.
• Adjusting the volume.
• Switching the power to on or off.
GB
26
*
*
Set the command mode of the remote to the
2nd zone mode.
Move the easy scroll key to select "2ND
ZONE", then press the key to enter the
selection.
To select the 3rd zone mode
(STR-DA5000ES only)
Move the easy scroll key to select "3RD
ZONE", then press the key to enter the
selection.
Tips
• Only when the remote is turned on by pressing
SOUND FIELD or INPUT SELECTOR, the
COMMAND MODE appears in the first line of the
display.
• Make sure that the command mode of the remote and
the main receiver is the same.
Note
The 2nd (or 3rd) zone mode is available for STR-
DA5000ES models of area code U, CA only.