Honeywell CARMEL 50196 Manual page 17

30. Remove the battery cover from the back of the
remote (Fig. 30). After removing the protective
plastic, insert the battery. Replace the battery cover.
D/CFL Switch: Located inside the battery
compartment of the remote, this switch should
be moved to either "D" for dimmer or "CFL" for
compact fluorescent bulbs depending on which
type of bulbs you've installed in the fan.
Note: The switch is pre-set to "CFL". Move the switch
to "D" to correspond with the included incandescent
bulbs which will enable the dimming function.
Important: The dimmer function does not work with
CFL bulbs.
31. To operate the fan using the remote, press and
release the following buttons (Fig 31):
1 - High fan speed
2 - Medium fan speed
3 - Low fan speed
4 - Power - Turns the fan off.
Light Delay Off mode - Press and hold the power
button (4) for five seconds, which will turn off light
after one minute. The LED indicator on the remote
will flash four times to confirm mode setting.
5 - Light Control - Press button to turn lights off and
on (all bulbs). Press and hold light control to dim or
brighten the lights (incandescent bulbs only).
OPERATING INSTRUCTIONS
17
Fig. 30
D/CFL Switch
Battery
Compartment
Battery Cover
Fig. 31
1
2
3
4
5
Remote
Control
Remote
Battery