Listening To Audio From A Connected Component; Recording Audio From A Connected Component - Sony MHC-GS100 Operating Instructions Manual

Listening to audio from a
connected component
Listening to the analog sound
of an MD deck, a VCR, etc.
1
Connect the audio cords.
See "Hooking up optional components" on
page 24.
2
Press VIDEO (MD) to select "VIDEO" or
"MD".
Start playing the connected component.
To switch the VIDEO function to MD
When you listen to a connected MD deck,
perform the following operation.
1
Turn off the system.
2
Press VIDEO (MD) while holding down
STOP x.
The function switches to MD.
Tip
Once you enable the MD function, just press VIDEO
(MD).
Notes
• The function is factory-set to VIDEO.
• If you want to switch back to the VIDEO funtion,
perform the operation described above to switch to
the VIDEO function.
• You cannot switch the function in Power Saving
Mode.
Recording audio from a
connected component
1
Connect the audio cords.
See "Hooking up optional components" on
page 24.
2
Start recording manually.
See "Recording to a tape" on page 18.
US
25