Also Available From Seco-Larm; Troubleshooting - SECO-LARM SD-996C-NUVQ Manual

SECO-LARM Electric Door Strike with Vertical Adjustment

Also Available from SECO-LARM

Door Strikes
Fail-safe or fail-secure
available
SD-995C / SD-994C shown

Troubleshooting:

Electric strike does not activate
Door does not open when the
electric strike is activated
Strike makes a buzzing sound
LIMITED WARRANTY: This SECO-LARM product is warranted against defects in material and workmanship while used in
normal service for three (3) years from the date of sale to the original customer. SECO-LARM's obligation is limited to the
repair or replacement of any defective part if the unit is returned, transportation prepaid, to SECO-LARM. This Warranty is
void if damage is caused by or attributed to acts of God, physical or electrical misuse or abuse, neglect, repair or alteration,
improper or abnormal usage, or faulty installation, or if for any other reason SECO-LARM determines that such equipment is
not operating properly as a result of causes other than defects in material and workmanship. The sole obligation of
SECO LARM and the purchaser's exclusive remedy, shall be limited to the replacement or repair only, at SECO-LARM's
-
option. In no event shall SECO-LARM be liable for any special, collateral, incidental, or consequential personal or property
damage of any kind to the purchaser or anyone else.
NOTICE: The SECO-LARM policy is one of continual development and improvement. For that reason, SECO-LARM
reserves the right to change specifications without notice. SECO-LARM is also not responsible for misprints. All trademarks
are the property of SECO-LARM U.S.A., Inc. or their respective owners. Copyright © 2019 SECO-LARM U.S.A., Inc. All
rights reserved.
SECO-LARM
16842 Millikan Avenue, Irvine, CA 92606
Phone: (949) 261-2999 | (800) 662-0800
8
Door Holders
Surface-mount or
flush-mount available
DH-151SQ shown
 Unmount the strike and check that the electrical connector is
connected properly.
 Ensure the electrical connector is connected to a 12 or 24VDC
source.
 Use a multimeter to test that the strike is receiving the proper
voltage and amperage. If it is not, it may be necessary to use
heavier gauge wires, or increase the output of the power supply.
 Make sure the activation device (keypad or push-button switch) is
working properly.
 Check that the door latch is operating properly, and replace if
necessary.
 The position of the electric strike may need to be adjusted by
moving it or adding washers or shims.
 Connect the strike to a DC power supply.
® U.S.A., Inc.
®
:
Magnetic Locks
80, 300, 600, and 1200-lb
holding force available
E-941SA-1200 shown
Website: www.seco-larm.com
Email: sales@seco-larm.com
Exit Devices
Stainless-steel,
Fits doors 30"~48"
SD-962AR-36A shown
MI_SD-996C-NUVQ_190626.docx
SECO-LARM U.S.A., Inc.
PITGW1