Amtrol THERM-X-TROL STL (CL) SERIES Replacement Instructions

NOTE: Inspect for shipping damage and notify freight carrier or store where purchased immediately if damage is present. To avoid risk of personal
injury and property damage, if the product appears to be malfunctioning or shows signs of corrosion, call a licensed professional immediately. Current
copies of the Product manual can be viewed at www.amtrol.com. Use proper safety equipment when installing.
THIS IS THE SAFETY ALERT SYMBOL. IT IS USED TO ALERT YOU TO POTENTIAL PERSONAL INJURY AND OTHER
HAZARDS. OBEY ALL SAFETY MESSAGES THAT FOLLOW THIS SYMBOL TO REDUCE THE RISK OF PERSONAL
INJURY AS WELL AS PROPERTY DAMAGE.
READ
INSTALLATION INSTRUCTIONS. FAILURE TO
FOLLOW THE INSTRUCTIONS AND WARNINGS MAY RESULT IN
SERIOUS OR FATAL INJURY AND/OR PROPERTY DAMAGE, AND
WILL VOID THE PRODUCT WARRANTY. THIS PRODUCT MUST BE
INSTALLED BY A LICENSED PROFESSIONAL.
APPLICABLE LOCAL AND STATE CODES AND REGULATIONS. IN
THE ABSENCE OF SUCH CODES, FOLLOW THE CURRENT EDITIONS
OF THE NATIONAL PLUMBING CODE AND NATIONAL ELECTRIC
CODE, AS APPLICABLE.
EXPLOSION OR RUPTURE HAZARD. THE
EXPANSION TANK MUST BE OPERATED SO
THAT THE PRESSURE DOES NOT EXCEED THE MAXIMUM
WORKING PRESSURE.
This Product, like most Products under pressure,
may over time corrode, weaken and burst or
explode, causing serious or fatal injury, leaking or flooding and/or property
damage. To minimize risk, a licensed professional must install and
periodically inspect and service the Product. A drip pan connected to an
adequate drain must be installed if leaking or flooding could cause
property damage. Do not locate in an area where leaking could cause
property damage to the area adjacent to the appliance or to lower floors
of the structure.
THERM-X-TROL
Nut
Adapter
Diffuser
Drain
Stand
Blind Flange
CAREFULLY THE PRODUCT
FOLLOW ALL
®
FOR USE ONLY WITH POTABLE WATER SYSTEMS
REPLACEMENT BLADDER INSTRUCTIONS
Models ST-35L(CL) through ST-600L(CL)
Lifting Ring
Air Charge
Flange Ring
Elbow
excess of local code requirement or maximum working pressure
designated in the Product Manual, whichever is less. At least once every
3 years or if discharge is present, a licensed contractor should inspect the
temperature and pressure relief valve and replace if corrosion is evident
or the valve does not function. FAILURE TO INSPECT THIS VALVE AS
DIRECTED COULD RESULT IN UNSAFE TEMPERATURE OR
PRESSURE BUILD-UP WHICH CAN RESULT IN PRODUCT FAILURE,
SERIOUS INJURY OR DEATH AND/OR SEVERE PROPERTY DAMAGE
AND VOID THE PRODUCT WARRANTY.
where the temperature can exceed 240°F and do not exceed the
maximum working pressure specified in the Manual. Mount vertically only.
You should test for corrosive elements, acidity, total solids and other
relevant contaminants, including chlorine and treat your water appropriately
to insure satisfactory performance and prevent premature failure.
cause cancer and birth defects or other reproductive harm. For more
information go to www.P65Warnings.ca.gov.
STL (CL) SERIES
Lifting Ring
Bladder
EXPLOSION OR RUPTURE HAZARD. A relief
valve must be installed to prevent pressure in
Use only with potable water systems. Do not
operate in a setting with freezing temperatures or
Chlorine & Aggressive Water: The water quality
can significantly influence the life of this Product.
This product can expose you to chemicals including
lead, which is known to the State of California to