Shure cartridges can be used in DJ or Hi-Fi applications. Note: the M70BX
is not recommended for heavy scratching.
1. Carefully remove the stylus from the
cartridge. See Figure 1.
2. Use needle-nose pliers to connect the
colored wires from the tonearm headshell
to the corresponding pins on the cartridge.
See Table 1 and Figure 2.
HEADSHELL WIRE
RIGHT "HOT"
RIGHT GROUND
LEFT "HOT"
LEFT GROUND
Table 1. Cartridge Wiring
3. Attach the cartridge to the headshell us-
ing the screws supplied. See Figure 3.
Tighten the screws after positioning the
cartridge (and headshell weight, if desired)
according to one of the methods described
below.
4. Carefully insert the stylus into the car-
tridge.
Choose a Method for Cartridge Positioning
Hi-Fi Setup: For maximum fidelity and minimal record wear,
position the cartridge using an alignment protractor or the overhang
gauge supplied with your turntable. Level your tonearm (See
Figure 7). Use Table 2 and "Setting a Precise Tracking Force",
below, to set the typical tracking force for your cartridge. Set the
anti-skate control to the same number as the tracking force.
É É É É É É É É É É É É É É
É É É É É É É É É É É É É É
Install Your Cartridge
COLOR
PIN
RED
R
GREEN
RG
WHITE
L
BLUE
LG
É
Standard DJ Setup: Mount cartridge at rear of
headshell. Set tonearm height to 4-5. Set tracking
force to 3 grams. Set anti-skate control to 0.
Shure Incorporated
222 Hartrey Avenue
Evanston IL 60202-3696 U.S.A.
44, 35, AND 70 SERIES CARTRIDGES
SC35C
Optional Headshell
Weight (part number
at front)
Figure 4
Figure 1
M44
Figure 2
Figure 3
É É
É É
É É