Using The Simple Start In Boost Mode - Black & Decker SIMPLE START BB7B Instruction Manual

BB7B_Manual EN_082406 8/24/06
• Never smoke or allow a spark or flame in vicinity of vehicle battery,
engine or battery booster.
• Remove personal metal items such as rings, bracelets, necklaces and
watches when working with a lead acid battery. A lead acid battery can
produce a short circuit current high enough to weld a ring, or the like of a
metal, causing a severe burn.
• Read and understand this instruction manual before using this unit.
SAVE THESE INSTRUCTIONS
INTRODUCTION
Thank you for choosing the Black & Decker
compact, durable, portable jump-start system for vehicles and boats that
have a standard 12 volt battery system and a 12 volt DC accessory outlet.
This self-contained, rechargeable system will charge most vehicle systems
and boats without the need for a host vehicle or 120 volt AC power supply.
The BB7B can also be used as a portable source of 12 volt DC electric
power for use with 12 volt DC cordless, rechargeable products and DC/AC
power inverters. The unit's long-life LED Area Light provides proper lighting
for connecting the unit to a vehicle's accessory outlet.
NOTE: THIS UNIT IS DELIVERED IN A PARTIALLY CHARGED STATE – YOU
MUST FULLY CHARGE IT BEFORE USING IT FOR THE FIRST TIME.
INITIAL 120 VOLT AC CHARGE TIME SHOULD BE FOR 15 HOURS.
Please read this manual carefully before use to ensure optimum performance
and avoid damage to the unit or items that you are using it with.
FEATURES
• Battery boosts/charges without the need of another vehicle and without
having to leave the vehicle in need of a jump-start — using the vehicle's 12
volt DC accessory outlet and the built-in, fused 12 Volt DC Vehicle Charger.
• 12 Volt DC Outlet for powering and recharging accessories and
appliances.
• Ultra bright, long-life LED Area Light.
• Includes 3 non-spillable, maintenance-free, heavy-duty, sealed lead
acid batteries.
• Rechargeable with supplied 120 Volt AC Charger.
• Requires no maintenance (other than recharging) for optimum operation.
• Molded high-impact case is tough and durable.
10:14 AM Page 5
® Simple Start ™ . This unit is a
5
Controls and Indicators
FUSED 12 VOLT DC VEHICLE
CHARGING CORD
BATTERY
POWER LED VEHICLE BOOST STATUS LED
INDICATOR LED INDICATOR INDICATOR
12 VOLT DC
OUTLET
ON/OFF RECHARGE
VEHICLE BOOST
POWER PUSHBUTTON UNIT
PUSHBUTTON PUSHBUTTON
USING THE SIMPLE START ™ IN BOOST MODE
Make sure the unit is sufficiently charged before attempting to use this
feature (see the "Charging/Recharging" section on page 8).
1. Turn off headlights, cabin light, radio and all other vehicle accessories
before using the SimpleStart ™ in boost mode.
2. Turn the unit ON by pressing the ON/OFF Power Push button. The unit
will beep once and the red Power LED Indicator and Battery Status LED
Indicator will light to indicate it is functioning.
3. Remove the 12 Volt DC Vehicle Charging Cord from its storage
compartment and plug it into the vehicle's 12 volt DC accessory outlet.
4. Press the Vehicle Boost Push button. If properly connected, the unit will
beep once again and the Vehicle Boost LED Indicator will flash green ,
indicating the vehicle battery is being charged/boosted. If the unit beeps
continuously, recheck plug connection. If plug is properly connected and
the unit still beeps continuously, your vehicle's ignition key may need to be
in the accessory (ACC) position to activate the 12 Volt DC outlet. If so turn
the unit off, turn the ignition key to the accessory position, turn the unit
back on and press the Vehicle Boost Push button.
VEHICLE CHARGING CORD
STORAGE COMPARTMENT
12 VOLT DC
CHARGING PORT
LED
EMERGENCY
LIGHT
LED AREA LIGHT
ON/OFF PUSHBUTTON
6