Overview Of Bios Features; Introduction; Bios Flash Memory Organization; System Management Bios (Smbios) - Intel NUC8i5INH Technical Product Specification

3

Overview of BIOS Features

3.1

Introduction

The board uses an Intel NUC BIOS that is stored in the Serial Peripheral Interface Flash Memory
(SPI Flash) and can be updated using a disk-based program. The SPI Flash contains the BIOS
Setup program, POST, the PCI auto-configuration utility, LAN EEPROM information, and Plug and
Play support. The initial production BIOSs are identified as INWHL357.
The BIOS Setup program can be used to view and change the BIOS settings for the computer. The
BIOS Setup program is accessed by pressing the <F2> key after the Power-On Self-Test (POST)
memory test begins and before the operating system boot begins.
NOTE
The config menu is displayed only when the board is in configuration mode. Section 2.3 on page
44 shows how to put the board in configuration mode (Jumper removed).
3.2

BIOS Flash Memory Organization

The Serial Peripheral Interface Flash Memory (SPI Flash) includes a 128 Mb (16384 KB) flash
memory device.
3.3

System Management BIOS (SMBIOS)

SMBIOS is a Desktop Management Interface (DMI) compliant method for managing computers in
a managed network.
The main component of SMBIOS is the Management Information Format (MIF) database, which
contains information about the computing system and its components. Using SMBIOS, a system
administrator can obtain the system types, capabilities, operational status, and installation dates
for system components. The MIF database defines the data and provides the method for
accessing this information. The BIOS enables applications such as third-party management
software to use SMBIOS. The BIOS stores and reports the following SMBIOS information:
 BIOS data, such as the BIOS revision level

Fixed-system data, such as peripherals, serial numbers, and asset tags
 Resource data, such as memory size, cache size, and processor speed
 Dynamic data, such as event detection and error logging
Non-Plug and Play operating systems require an additional interface for obtaining the SMBIOS
information. The BIOS supports an SMBIOS table interface for such operating systems. Using
this support, an SMBIOS service-level application running on a non-Plug and Play operating
system can obtain the SMBIOS information. Additional board information can be found in the
BIOS under the Additional Information header under the Main BIOS page.
53