GE WH00X5630 Part Instruction page 2

GE Appliances & Lighting
Part Instruction
The drum slide assembly is located on the
back side of the front panel and utilizes 4
drum slides. Two white outer slides
WE1M504 are used as guides, and 2 green
center (top) slides WE1M1067
support the weight of the drum.
Caution: Do not replace the center (top)
support slides WE1M1067
guide slides WE1M504. Damage to the
dryer will result.
GE Appliances & Lighting
General Electric Company
Louisville, KY 40225
GEAppliances.com
are used to
with the white
WE49X20697
To remove the drum slide top
bearing assembly:
1. Remove the light bulb (if present).
2. Grasp the top of the drum slide
bearing assembly and pull down and
inward to release the assembly from
the 2 tabs located at the top of the
front panel.
3. Reassemble
Drive Belt
The drive belt WE12M22 is a 4-rib belt and
extends from under the motor pulley, over
the top of the idler pulley, and around the
perimeter of the dryer drum. Belt tension is
maintained by the idler pulley and driven
by a pulley attached to the motor shaft.
To remove the drive belt:
1. Reach under the left-hand side of
the drum, push the idler pulley
down and to the right, and lock the
idler arm on the top corner of the
motor bracket to release belt
tension.
WH00X5630