Inserting Batteries Into The Remote Control; Easy Setup Procedure - Sony DST-HD500 Operating Manual

Inserting batteries into the remote control

1
Push and lift up the release clip to
remove the battery cover.

Easy Setup procedure

Easy Setup screen
Easy Setup
Time Setup VIC
Full Scan
Quick Scan
Select your State / Region.
Select : Confirm :
1 Press the 1 (Power) button on the front of the receiver. When
the receiver is switched on for the first time, the 'Easy Setup'
screen is displayed.
2 With the Time Setup option highlighted, press the
button. Then press the V or v buttons to select your state/region.
Note:This option allows you to set the time zone in which you are using
the receiver. This will ensure that the time displayed on the i-Plate is
correct.
Exit :
3 Press the V or v buttons to highlight Full Scan or Quick Scan
to preset channels.
'Full Scan'
'Quick Scan' All expected channels in your area are tuned and
Press the OK button to begin the autotune procedure. A display
appears showing a tuning progress bar and the channels found.
4 When autotune procedure has finished, the Program List is
displayed, showing all the available channels.
Press the OK button to remove the Program List and view the
first channel captured.
Alternatively, press the v button to select a different channel.
Press the OK button to remove the Program List and view the
selected channel.
If no channels are found
1 If no channels have been captured and stored, a message
appears on screen to inform you.
2
Check your aerial cable is connected, then press the MENU
button and select Install menu to repeat the autotune
procedure.
3 If you are still unable to receive signals, please have your aerial
checked by an aerial installation company.
2
Insert the supplied batteries as
indicated inside the battery
compartment.
All available channels are tuned and stored. This
procedure may take up to 15 minutes.
stored. You will need to select your nearest city to
help speed up this procedure.
Getting Started
Getting Started
b
or OK
11