Sony VPL-VW60 Operating Instructions (VPL-VW60) Operating Instructions Manual page 55

Symptom
The picture flickers.
The color of characters or
the picture is not
appropriate.
On-screen display
Symptom
On-screen display does not
appear.
The model name does not
disappear from the screen.
Remote control
Symptom
The remote control does
not work.
Others
Symptom
The fan is noisy.
Cause and Remedy
c Activate "APA", then adjust the current input signal.
c Adjust "Phase" for "Adjust Signal" in the Screen
properly. (1 page 45)
c Select the desired color registration in "Panel Alignment" of
Installation menu (1 page 51).
Cause and Remedy
c Set "Status" in the Setup
? 1
c Check if the
/ (ON/STANDBY) indicator should light in
green.
c The display mode of the projector may be set at the time of
purchase. Consult with your local dealer or qualified Sony
personnel.
Cause and Remedy
c Batteries could be weak. Replace them with new batteries.
(1 page 11)
c Insert the batteries with the correct polarities. (1 page 11)
c In the Installation
"Front & Rear". (1 page 50)
c If there is a fluorescent lamp near the remote control detector, the
projector may work improperly or inadvertently. Change the
setting of "IR Receiver" in the Installation
Cause and Remedy
c Check the setting of "Cooling Setting" in the Setup
(1 page 46)
c Make sure that the room temperature is not too high.
Check the installation conditions. (1 page 12)
The number of fan rotation increases to maintain the product
reliability of the projector's components in a room, where the
temperature is higher than normal. The fan noise becomes
slightly louder. The approximate normal temperature is 25°C.
menu to "On." (1 page 46)
menu, set the setting of "IR Receiver" to
menu
menu. (1 page 50)
menu.
55