Projecting; Projecting The Picture On The Screen - Sony Bravia VPL-VW40 Operating Instructions Manual

Projecting

This section describes how to operate the projector to view the picture from the equipment
connected to the projector. It also describes how to adjust the quality of the picture to suit
your taste.

Projecting the Picture on the Screen

Example: To view the picture
from the video
equipment connected
to the VIDEO INPUT
connector.
To view the picture from
Video equipment connected to the VIDEO INPUT connector
Video equipment connected to S VIDEO INPUT connector
Component equipment connected to Y P
RGB/component equipment connected to the INPUT A connector
Equipment connected to the HDMI 1 connector
Equipment connected to the HDMI 2 connector
* Set the "Input-A Signal Sel." setting in the Setup
you set it to "Auto," and cannot display the picture properly, select an appropriate signal
according to the input signal. (1 page 47, 51)
** Make the setting on the equipment connected with HDMI cable according to the HDMI
standards.
The color gradation of the dark area or the bright area may become unclear, or texts may become
faded when a signal other than those from HDMI standard is input. Adjusting the "Brightness"
and the "Contrast", or adjusting the "Sharpness" in the Picture
conditions. (1 page 41)
1
Power on both the equipment
and the device connected to the
equipment.
2
Press INPUT repeatedly to
select the input you want to
project on the screen.
Display the indication of the input you
want.
/C P /C on the projector Component
B B R R
menu according to the signal input. When
Press INPUT to display
Video
S-Video
Input-A*
HDMI1**
HDMI2**
menu may improve these
27