General - Sony GRAND WEGA 2-059-370-14(2) Operating Instructions Manual

General

Problem
How to reset TV to factory
settings
How to restore Video settings
to factory settings
How to restore Audio settings
to factory settings
Cannot cycle through the other
video equipment connected to
the LCD projection TV
Cannot operate Menu
Lost password
TIMER/STANDBY LED on
front panel is lit
Digital cable box does not work
Cannot record digital channels
to VCR
The replacement lamp does not
light up
TV cabinet creaks
Possible Remedies
❏
Turn on the TV. While holding down the
press the POWER button on the TV. (The TV will turn itself off, then back on
again.) Release the RESET
❏
Press RESET on the remote control while in the Video menu (see page 98).
❏
RESET
Press on the remote control while in the Audio menu (see page 102).
❏
Be sure the Label Video Inputs
❏
If a menu option appears in gray, this indicates that the menu option is not
available.
❏
In the password screen (see page 108), enter the following master password:
4357. The master password clears your previous password; it cannot be used to
temporarily unblock channels.
❏
The LED (see page 24 or 126) blinks when the TV is turned on, then shuts off
when the picture is displayed. If the LED blinks continuously, this may indicate
the TV needs service. When lit, indicates that the timer is set (see page 24 or 126).
When the timer is set, this LED will remain lit even when the TV is turned off.
❏
If you are connecting a VCR and digital cable box using a splitter, as described on
page 41, you must use a special bi-directional splitter that is designed to work
with your digital cable box. Contact your cable provider for details.
❏
Only analog channels can be recorded to your VCR.
❏
The screw of the lamp cover may be slanted. Take out the screw, insert it straight
into the screw hole, and then tighten it completely (see page 19 for KDF-WE655
series, see page 22 for KDF-WF655 series).
❏
When the TV is in use, there is a natural rise in temperature, causing the cabinet to
expand or contract and may be accompanied by a slight creaking noise. This is not
a malfunction.
RESET button on the remote control,
button.
option is not set to Skip
Other Information
(see page 113).
125