Flow Chart Of Troubleshooting - Samsung GT-E1210S Service Manual

9. Flow Chart of Troubleshooting

9-1. Power On
'POWER ON' does not work
Yes
Check battery voltage
is higher than 3.3V
OK
Check VPERM_3.0V,
VANA_2.85V, VRF_2.85V,
VSIM_3.0V, VMEM_1.8V,
VGPIO_2.8V of UME200
OK
Check the pin 1 of
OSC200 produces clock
signal
OK
Check the R406
concerning about Jig
Power on
OK
Is Power On working?
Yes
END
SAMSUNG Proprietary-Contents may change without notice
This Document can not be used without Samsung's authorization
Not OK
Not OK
Not OK
Not OK
No
9-1
Change battery
Check the UCP200
Solder OSC200 again
Solder R406 again
Repeat sequence