Table of Contents
Advertisement
1
2
3
Input VAC VDC Min
Alarm
Normal
A.V.R.
8
7
3
Installation and set-up
3.1
Unpacking the UPS equipment
The manufacturer has designed robust packaging for your product to help ensure it reaches you in good order. However,
accidents and damage can sometimes occur during shipment so you should inspect the UPS carefully upon receipt and
inform the carrier and dealer immediately if there are signs of damage.
WARNING: Under no circumstances should you connect electrical power to a damaged unit or attempt to
start it using its internal batteries.
Save any recyclable packaging for re-use or dispose of it following local environmental practices.
1.
Remove the UPS from the packing carton.
2.
Check the package contents. The standard unit includes:
• 1x UPS Power Unit
• 1x IEC input power cable fitted with a suitable AC Mains plug
• 1x User Manual
3.
Check the data plate on the rear of the UPS and verify that the unit's voltage and power ratings comply with the
equipment order details. Contact the dealer immediately if this is incorrect.
3.2
Selecting a suitable installation location
To ensure optimum UPS operation and long service life, always install the UPS in a location that meets the following
environmental standards:
• The ambient temperature is between 0°C and +40°C. A temperature of 20°C is ideal for optimum battery lifespan
• The ambient humidity does not exceed 90% (non condensing)
• The installed location is clean, dry and free of excessive dust
• The UPS must not be installed in direct sunlight
• The UPS must not be installed near water or any other source of liquid
• The UPS must not be installed in a corrosive environment or in the vicinity of flammable items
• A minimum clearance of 2.5 cm (1 inch) must be provide around the UPS case to allow adequate heat dissipation
• The UPS must be installed within 2m of a utility AC mains power socket
TS_602_01 PW1000/LT User Manual 20/3/19
Key
4
5
1
2
Output VAC
3
4
Backup
5
6
5
6
6
Figure 2.2 PW1000LT LCD Display Panel (option)
Description
Line mode
Input / battery voltage metering
Fault: UPS abnormal condition
Output voltage metering
Battery mode
Load level (in 25% blocks)
Automatic Voltage Regulation (AVR) mode
Battery capacity (in 25% blocks)
3
Advertisement
Table of Contents
