Honeywell Touchpoint Plus Wireless Technical Handbook page 71

3020M5001_Iss 1_07/18
8.1.2 Exercising the relays
Relay output channels can be tested by forcing the relays to an active state:
1) Login with a valid engineer or higher level password
2) Select the Menu>System test >Force Relay
3) Select the Relay module to be tested, and toggle it off and on for the specific Relay channel
4) Check the relay out contact using a voltage meter
5) Repeat steps 3 and 4 for all relay output channels
8.1.3 Exercising Audio/visual alarm
Audio/visual alarm can be tested by forcing signal out:
1) Login with a valid engineer or higher level password
2) Select the Menu>System test >Dedicated Alarm Contacts
3) Toggle it off and on for each outputs
4) Check the voltage level using a voltage meter
Maintenance
Ensure that the system is returned to normal operation once testing is complete.
Caution
65
Touchpoint Plus Wireless
Technical Handbook