LG LP1419IVSM Owner's Manual page 14

14 INSTALLATION
14 INSTALLATION
3 Inserting Panel Assembly
Insert the panel assembly in the bottom sash channel as in step 2. Use care when installing the assembly, which will
now fit very tightly in the opening. Close the sash tightly against the top of the panel assembly. For a tighter seal, use
"no residue" duct tape (not included) to seal any gaps around the installed panel assembly.
• If needed, install the included security bracket with a type K screw.
Panel A
4 Sealing Gap between Sashes
Measure and cut the included non-adhesive foam E to fit the window opening. Stuff it between the window sashes to
prevent air and insects from getting into the room.
Tip. For a tighter seal, use "no residue" duct tape to seal the gap between the sashes.
5 Connecting Vent Hose
Align the tabs on the diffuser end of the vent hose to the slots in the panel assembly opening. Insert the diffuser and
rotate it to lock it in place.
• If disconnected, reconnect the other end of the vent hose to the product by inserting the vent hose into the product
with the mounting ring facing out. If the hose doesn't snap into place, rotate it slightly so the 2 lines at the front align.
4
Non-adhesive
foam E
6 Positioning Vent Hose
For best results, keep the vent hose as short and straight as possible. However, shape the diffuser end of the vent
hose into an inverted U shape just inside the window to allow any rain or condensation to drain out the window.
Best positioning
Extension
panel
Type K
screw
5
Mounting ring
(1) Insert
Inverted U shape
Security
bracket
(2) Lock