46
VAIO Digital Studio™ System Reference Manual
To install a 3.5-inch internal hard disk drive (all models)
1
Configure the jumpers on the new drive as a slave device (see your
drive's documentation for configuration instructions).
2
Remove the side cover (see
3
Disconnect the drive connector (A in diagram).
4
Disconnect the power connector (B in diagram).
5
Pull out on the tab (C) that secures the drive holder to the chassis.
"Removing the Side Cover"
A
B
C
Power
connector
Jumpers
Drive
connector
on page 28).
Drive connector
Power supply
connector
Tab
Disk drive holder