Electrical Safety - Beko MSH28B Manual

Electrical safety

• If the product has a failure,
it should not be operated
unless it is repaired by an
Authorised Service Agent.
There is the risk of electric
shock!
• Only connect the product
to a grounded outlet/line
with the voltage and pro-
tection as specified in the
"Technical specifications".
Have the grounding instal-
lation made by a qualified
electrician while using the
product with or without a
transformer. Our company
shall not be liable for any
problems arising due to the
product not being earthed
in accordance with the lo-
cal regulations.
• Never wash the product by
spreading or pouring water
onto it! There is the risk of
electric shock!
• Never touch the plug with
wet hands! Never unplug
by pulling on the cable, al-
ways pull out by holding
the plug.
• The product must be dis-
connected during installa-
tion, maintenance, clean-
ing and repairing proce-
dures.
• If the power connection
cable for the product is
damaged, it must be re-
placed by the manufactur-
er, its service agent or sim-
ilarly qualified persons in
order to avoid a hazard.
• The appliance must be in-
stalled so that it can be
completely disconnected
from the mains supply. The
separation must be provid-
ed by a switch built into the
fixed electrical installation,
according to construction
regulations.
• Rear surface of the oven
gets hot when it is in use.
Make sure that the electri-
cal connection does not
contact the rear surface;
otherwise, connections can
get damaged.
• Do not trap the mains ca-
ble between the oven door
and frame and do not route
it over hot surfaces. Oth-
erwise, cable insulation
may melt and cause fire as
a result of short circuit.
• Any work on electrical
equipment and systems
should only be carried out
by authorised and qualified
persons.
5/EN