Check Rotating Floor Brush And Drive Belt; Replace Drive Belt - Bissell CleanView 3575 Series User Manual

Check Rotating Floor Brush and Drive Belt

You should check your vacuum cleaner's Rotating Floor Brush
and Drive Belt regularly for wear or damage. You should also
clean the brush and brush ends of strings, hair, and carpet
fibers. These can wrap around the brush and hamper its ability
to effectively clean your carpet. Also remove any debris that
has accumulated under the brush cover.
Unplug cleaner from electrical outlet.
1.
Place handle in Low position and turn vacuum cleaner
2.
over so bottom side is up.
Remove the four screws as shown with a Phillips head
3.
screwdriver. Lift the Brush Cover off.
Grasp Rotating Floor Brush at both ends and lift.
4.
Clean strings, hair and other debris from Rotating Floor
5.
Brush, paying particular attention to brush ends.
Clean strings, hair and other debris from Motor Pulley
6.
and Drive Belt areas.
Check Drive Belt carefully for wear, cuts or stressed areas.
7.
Check Air Passageway for obstructions. Remove debris
8.
from this area.

Replace Drive Belt

Use only BISSELL Style 7 Replacement Belts (#32074) in your
BISSELL CleanView.
Unplug cleaner from electrical outlet.
1.
With Rotating Floor Brush removed from vacuum cleaner
2.
(Steps 1-4 of check Rotating Floor Brush and Drive Belt),
grasp old Drive Belt and remove from Motor Pulley.
Discard old Drive Belt.
Place new Drive Belt over Motor Pulley and stretch other
3.
end over Rotating Floor Brush in the space between
the bristles.
Place ends of Rotating Floor Brush down into slots on
4.
sides as shown.
Turn Rotating Floor Brush by hand several times in the
5.
direction of Motor Pulley. If properly installed, Drive Belt
will center itself on Rotating Brush crown.
Reposition Brush Cover and screws. Tighten
6.
screws securely.
10
Note: The Power Trak models have an additional
screw which needs to be removed. See the 2nd
Illustration.
Power Trak models only
Motor Pulley
Air Passageway
Brush
Cover