Sony SRP-X500P Interface Manual page 32

•
SETUP STATUS
Shows the progress of the FEED BACK REDUCER setting.
The parameter and the progress are as shown in the following table.
Progress
Stopped (finished)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
♦ AV/RGB INPUT SELECT (56th byte)
Shows the selection of the channel input from among the AV/RGB INPUT connectors.
The parameter and the channel are shown in the following table.
Channel
OFF (All the AV RGB SELECT buttons are turned off.)
A (The AV RGB SELECT A button lights up.)
B (The AV RGB SELECT B button lights up.)
C (The AV RGB SELECT C button lights up.)
D (The AV RGB SELECT D button lights up.)
E (The AV RGB SELECT E button lights up.)
♦ SPEAKER OUTPUT LEVEL (57th, 58th byte)
Shows the level of the SPEAKER OUT controls on the front panel of the SRP-X500P.
The SPEAKER OUTPUT LEVEL parameter consists of the 2 bytes of data in the order shown in the
following table.
Byte Parameter
1st SPEAKER OUTPUT CH1/2 LEVEL
2nd SPEAKER OUTPUT CH3/4 LEVEL
The correspondence of the parameter with the speaker output level is the same as that of the LEVEL
parameter of the REMOTE 1-6 LEVEL command (page 10).
SRP-X500P RS-232C Interface Manual
0x30 ('0')
0x31 ('1')
0x32 ('2')
0x33 ('3')
0x34 ('4')
0x35 ('5')
0x36 ('6')
0x37 ('7')
0x38 ('8')
0x39 ('9')
0x3A (':')
0x3B (';')
0x3C ('<')
0x3D ('=')
0x3E ('>')
0x3F ('?')
Page 32/43
0x30 ('0')
0x31 ('1')
0x32 ('2')
0x33 ('3')
0x34 ('4')
0x35 ('5')