Bissell 3512 Series User Manual page 14

Grasp Rotating Floor Brush at both ends and lift up. Clean
4.
strings, hair and other debris from Rotating Floor Brush,
paying particular attention to brush ends.
Clean strings, hair and other debris from Motor Pulley and
5.
Drive Belt areas. Inspect entire Drive Belt carefully for wear,
cuts or stressed areas.
Check Air Passageway for obstructions. Remove debris from
6.
this area.
Reassemble unit (see steps 4-6 below).
7.
Replace Drive Belt
Replacement Belts
Use only BISSELL ®
Upright Vacuum Cleaner.
Unplug unit from electrical outlet.
1.
With Rotating Floor Brush removed (steps 1-5 above)from
2.
vacuum cleaner, stretch old belt to clear Motor Pulley, and
remove belt. Discard.
Place new Drive Belt over Motor Pulley and stretch other end
3.
over crown of Rotating Floor Brush.
Place belt end of Rotating Floor Brush into its slot and hold it
4.
in place with your left hand, while slowly pulling opposite end
of brush down into its slots with your right hand
Turn Rotating Floor Brush by hand several times in direction
5.
of Motor Pulley. If properly installed, Drive Belt will center itself
on Rotating Brush crown.
Position Brush Cover Tabs in the four Brush Cover slots along
6.
front of Powerfoot, and snap Brush Cover into place.
10
Replacement Belt Style 2 (#32015) in your
Tip:
This is a good
time to clean
the Slide Track
area of hair,
string, dirt,
or other
obstructions.
3
4
6