N199 - Emerson REED Series Manual

C
MOUNTING ON PROFILED BARREL OR TIE ROD CYLINDERS:
1 - Turn the detector's knurled nut by 90° so that it is retracted in-
side..
2 - Place the detector into the fastening kits' groove.
3 - Hold the detector in place as you tighten the screw (1/2 turn).
4 - Place the unit on one of the bosses or tie rods and position it at
the desired sensing point.
5 - Make sure that the detector is in contact with the barrel and
tighten the unit on the cylinder (use a 2 mm hexagon wrench).
It is possible to mount additional magnetic detectors.
I
for intermediate position indication.
In order to fasten the detector with its electric outlet to the rear,
II
mount the detector + the mounting bracket.
The detectors can be mounted on any one of the 4 bosses or
III
tie rods.
PES-PCN CYLINDERS WITH TIE RODS Ø 25 to 200
I
25/30
II
25/30
Ø cyl. 25 32 40 50
D 24 30 33 38
E 24 26 30 35
PES CYLINDERS WITH PROFILED BARREL Ø 32 to 125
I
25/30
ROUND CYLINDERS FASTENING KIT
CODE FASTENING KIT
Ø
cylinder
plastic
8-10 -
12

N199-1038

16 N199-1039
20 N199-1040
N199-1041
25
32 N199-1042
40 N199-1043
50 -
63 -
80 -
D
63 80 100 125 160 200
44 50 69 77 89 104
39 49 61 69 87 101
D
stainless
steel
N199-1037
N199-1054
N199-1054
N199-1055
N199-1055
N199-1056
N199-1058
N199-1044
N199-1045
N199-1046
Cylinder with
profi led barrel
3
III
E
4
5
II III
E max.
PROFILED BARREL OR TIE ROD
CYLINDER FASTENING KIT
125-160-200
8
1
Cylinder with
tie rods
2
C. max: 0,5 N.m
Ø cyl. 32 40 50 63
D 28 32 37 41
E 28 31 36 40
Ø CODE
cylinder FASTENING KIT
25 N199-1051
32-40 N199-1047
50-63-80 N199-1048
100 N199-1049
N199-1050
2
3
4
5
80 100 125
58 65 73
54 62 73