Dimplex HAW1000N Installation And Operating Instructions

Air Warmer: Model No. HAW1000N
Dimensions
(millimetres)
Watts Electrical Supply
1000W 230-240V ~1PN
THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE
Important Safety Advice
This appliance can be used by children aged from
8 years and above and persons with reduced
physical, sensory or mental capabilities or lack of
experience or knowledge if they have been given
supervision or instruction concerning the use of
the appliance in a safe way and understand the
hazards involved. Children shall not play with the
appliance. Cleaning and user maintenance shall
not be made by children without supervision.
Children of less than 3 years should be kept away
unless continuously supervised. Children aged
from 3 years and less than 8 years shall only
switch on/off the appliance provided that it has
been placed or installed in its intended normal
operating position and they have been given
supervision or instruction concerning the use of
the appliance in a safe way and understand the
hazards involved. Children aged from 3 years and
less than 8 years shall not plug in, regulate and
clean the appliance or perform user maintenance.
CAUTION: Some parts of this product can
become very hot and cause burns. Particular
attention has to be given where children and
vulnerable people are present.
WARNING: In order to avoid overheating, do not
cover the heater.
WARNING: This heater is not equipped with a
device to control the room temperature. Do not
use this heater in small rooms when they are
occupied by persons not capable of leaving the
room on their own, unless constant supervision
is provided.
An all-pole isolating switch with a minimum
separation of 3mm in each pole must be fitted
adjacent to the heater to facilitate local isolation.
DO NOT locate above or below a fixed socket
outlet.
WARNING: This heater has been designed for
horizontal floor mounting with the supplied guard
fitted over the product. Any other installation type
is not recommended.
Weight (kg)
14
Installation and Operating Instructions
115
470
The heater including the supporting legs can get very hot;
therefore do not mount directly on any combustible material.
Suitable fire resistant material is required between the
heater and any combustible base or support.
WARNING: Before obtaining access to the terminals all
supply circuits must be disconnected.
The heater should be installed to allow a reasonable air
flow around the heater.
A prominent notice should be provided where the heater is
sited 'Keep Clear and Unobstructed'.
Avoid exposure to water.
The heaters are not suitable for general domestic use.
The heater is suitable for a drying room provided that the
heater has suitable ventilation.
A mains lead which can operate at + 110°C must be used.
General
This carton contains:
•
1 HAW1000N heater
•
1 Foldable guard
Electrical connection
WARNING: THIS APPLIANCE MUST BE EARTHED.
Verify that the electrical supply cable is sufficient for the rated loading.
Check that the incoming supply conforms to the rated supply.
The heater power circuit must be protected by a suitably rated over
current device.
The incoming cables must be connected to the factory fitted heater
terminals provided. Do not alter any factory fitted wiring.
The Terminal Cover Casting can be removed to access the terminals, by
removing the 2 screws fixing the cover - see Fig. 2.
WARNING: Ensure the power cable path does not come into contact with
the heater element.
The heater is supplied with an earth stud, located inside the terminal box,
which must be connected to earth.
After connection check the continuity
08/50511/0 Issue 5
207
Fig. 1
of earth connections.
x
Fig. 2