Metrologic Optimus S Programming Manual page 124

118 "C" Programming Guide For Optimus S/R
Note: Only one network interface can be used at a time: 802.11b or PAN
Parameter
int DhcpEnable
unsigned char IpAddr[4]
unsigned char SubnetMask[4]
unsigned char
DefaultGateway[4]
unsigned char DnsServer[4]
char DomainName[129]
char LocalName[33]
char SSID[33]
int SystemScale
unsigned int WLAN_FLAG
int WepLen
int DefaultKey
unsigned char WepKey[4][14] Null
char EapID[33]
char EapPassword[33]
char ReservedByte[100]
Default Description
1 0: disable DHCP
1: enable DHCP
0.0.0.0 Local IP Address
0.0.0.0 Subnet Mask
0.0.0.0 IP address of Default
Gateway or router
0.0.0.0 IP address of DNS server
Null Domain Name
S/N Local host name.
By default, it shows the serial
number of terminal.
Null Service Set ID or AP name,
which is used for Remote
Device association.
2 Access Point Density,
determines when the terminal
should look for other AP that
has better signal strength.
1: Low
2: Medium
3: High
0x19 See WLAN_FLAG Structure
1 0: 64 bits Wep Key
(5 bytes to be configured for
the WepKey parameter)
1: 128 bits Wep Key
(13 bytes to be configured for
the WepKey parameter)
0 Use default Wep Key 0
WEP Key 0 ~ 3
Null ID to login EAP system
Null Password to login EAP
system
Null Reserved
WLAN SPP PAN
Read Read
only only