Advertisement
A l/2'' clearance below the window
stool is required.
If the storm window frame does not allow this
clearance, attach a 1 Yz" or 2" wide strip of wood
along the entire length of the window opening,
flush with the back side of the stool, or remove
the storm window for the air conditioning season.
Storm Window Frame
or Other Obstmction
REMOVE THE CHASSIS.
Remove the side retaining screws from
either side of the case.
Slide chassis from cabinet by holding with left
hand while pulling on handle at bottom front of
unit. Be careful of sharp edges on the coil fins.
If your unit has corrugated packing material inside
the cabinet it must be removed. Do not remove
the foam pads inside the cabinet. Foam blocks on or
around the compressor are to be removed. See note
attached to compressor for which blocks to remove.
NOTE: Handle is NOT intended for Iifiing the
unit. It is only for sliding the chassis out of the
cabinet for cleaning or maintenance.
2. /NflALL ~PRAIL AND SIDE
1. Attach foam gasket to top rail as shown.
2. Install top rail and side retainers to cabinet
as shown, using ten Type F screws.
(continued nextwge)
9
Advertisement
