Room Occupancy Monitor
Quick Guide Manual
For complete instructions, please see the
full Manual on the SECO-LARM website.
Overview:
Sensor
Phototransistor
PIR Sensor
PIR ON/OFF jumper*
Indicators
Buzzer
(1-Room Indicator only)
Antenna
*Phototransistor jumper's default is OFF, other jumpers' default is ON
Basic DIY Installation Using Micro USB Power:
The Room Monitor Kit (RM-R100-KB1Q) is pre-learned and ready to go right out of the box. Just mount and connect to
power via the included micro USB cable and any USB adapter. Follow the steps below for a basic installation.
1. Find a location to mount the Sensor/Indicator. Keep in
mind that the included micro USB cord is 12" long.
12"
(30cm)
3. Apply double-sided mounting tape to the back of the
Sensor/Indicator and mount.
Power
source
®
What's Included with the Kit:
1x Sensor
1x Indicator decals
1x Manual
Phototransistor ON/OFF jumper*
Pairing button
LED ON/OFF jumper*
Micro USB Power input
See full Manual for terminal block wiring instructions
Buzzer ON/OFF jumper* (1-Room Indicator only)
Service button (1-Room Indicator) / Ch2 Pairing button
Ch1 Pairing button
Micro USB power input
See full Manual for terminal block wiring instructions
2. Use a paper clip and program as needed. See Setting a
Reminder Time on pg. 2.
4. Connect the micro USB plug to the Sensor/Indicator
and connect to power.
1x 1-Room Indicator
2x 12" USB Power cords
(2-Room Indicator)