Siemens AR50M-MF User Manual page 15

Mullion Reader – User Manual
3. Insert the ridge on the end of the upper or lower terminal block into the corresponding slot.
4. Gently push the terminal block towards the base until it clicks.
5. Remove the Jumper 3 (see the diagram in Connecting the cables on page 13). Jumper 3 is used to
determine EOL. By default the reader has EOL ON. EOL is always off in Wiegand mode.
Please note that you must set the Jumpers to configure your application. For more information on
setting the Jumpers in Wiegand mode see Setting the Jumpers for Wiegand on page 17.
© Siemens 2019
15
Mounting and connecting
A-100417-b
15.04.2019