Terminal Blocks; Led Indicators; Engineering; Service Pin - Siemens DESIGO PX Series Manual

Terminal blocks

LED indicators

Service pin

Service pin

Engineering

4 / 10
Siemens
Building Technologies
The terminal blocks are removable for easy wiring.
Communication
RS232/RS485:
KNX:
The other LEDs have the following meaning:
LED Color Activity
Green Continuously ON
RUN
Continuously OFF
FAULT Red Continuously OFF
Continuously ON
Rapid flashing
LOW Red Continuously OFF
Continuously ON
BATT
Red Continuously ON
COMM
Continuously OFF
Flashing
INFO Red
Red Continuously OFF
SERVICE
(Ethernet, Continuously ON
PXC001- Flashing
Flashing per wink
E.D)
command *)
SERVICE Red Continuously OFF
(LonTalk,
Continuously ON
PXC001.D)
Flashing
Flashing per wink
command *)
*) Wink command pattern:
2s
Identification of the system controller in the IP network or L
See "Commissioning".
See the PX open documents in folder CM110761.
PXC001 System controllers
RX (Green) : TX (Yellow)
RX (Green) TX (Yellow)
Function
Power OK
No power
OK
Fault
Firmware missing / corrupt
Battery OK
Battery empty– replace!
Connection to switch OK
No connection to switch
Communication
Freely programmable
OK
No connection to switch
No IP address configured
Physical identification of system
controller after receipt of wink
command
L W
ON
Faulty L
currently depressed
L W
ON
Physical identification of system
controller after receipt of wink
command
21s
5 Hz 5 Hz
1s
2s
Service (Red)
node is configured
ORKS
W chip, or service pin
ON ORKS
node is not configured
ORKS
9222z02
1s
W network
ON ORKS
CM1N9223en_01
2014-04-04