Troubleshooting - Russound MBX-PRE Installation Manual

TROUBLESHOOTING

General Troubleshooting
This chart explains the operation of the LED:
System Status Yellow
Booting
Ready
Streaming Source is Active
Bluetooth Streaming
Bluetooth Pairing
Bluetooth Paused
Digital Input Active
Group/Party Mode
Standby Mode
Firmware Update
Network Error Blinking
Check for firmware updates available to make sure that your Russound
product is always up to date and to take advantage of any additional features
or supporting services that may be available.
Many issues can be resolved by power cycling the MBX-PRE by disconnecting
the power supply, waiting 15 seconds and re-connecting the power supply.
For networking issues, resetting network gear in the home such as the router
or any switches between the MBX-PRE and the router may also resolve any
issues.
If you have the MBX-PRE configured with a static IP address and do not
remember the settings, you can reset the MBX-PRE to DHCP by pressing and
holding the rear panel Reset button for 3 seconds. If there are any issues
reconnecting to the MBX-PRE after resetting to DHCP, unplug the MBX-PRE
from the network and re-connect it, or try power cycling the network router
to force a new DHCP connection.
18
Green Red Blue
ON
- - -
- - - -
- ON - -
ON
- - -
Blinking
- - -
- - - Blinking
- - - -
- - - -
- - ON -
Blinking
- - -
- - -
Russound MBX-PRE Installation Guide
For audio connection issues, verify all audio
connections from the MBX-PRE to the
controller/amplifier/receiver. If connected to
a Russound controller, verify that the source
Purple Cyan
number configured on the MBX-PRE matches
the source number that has been configured
- -
for it on the controller and that the input
- -
source type matches the correct type being
used (analog, coax, or digital).
- -
- -
Configuration Password
- -
- -
- ON
ON -
- -
- -
Within Web Config, there is an option in the
Setup-Systems Settings menu to Enable/
- -
Disable the Configuration Password.
password is disabled by default but can be
enabled to prevent inadvertent changes to
the MBX-PRE configuration. This is a simple
password system to make certain that you
want to make changes to key configuration
settings before making changes.
password is static and cannot be changed.
The configuration password, when enabled,
is: russound123
When enabled, this password must be entered
in order to change any configuration settings.
This
The