Sony LSPX-S1 Help Manual page 32

Glass sound speaker

Hide thumbs Also See for LSPX-S1:

Table of Contents

Hint

Once setup is complete, the speakers can be separated by more than 1 m (3 ft).

If you turn off the power while the Speaker Add function is in use, when you turn the power back on, the speaker will attempt playback using the

Speaker Add function. To use the Speaker Add function, turn on the other speaker.

If you want to use a speaker that was last used with the Speaker Add function by itself, turn on the speaker, then press the ADD (Speaker Add

function) button for at least two seconds to cancel the Speaker Add function.

If any other BLUETOOTH device(s), such as a BLUETOOTH mouse or BLUETOOTH keyboard, is connected to the BLUETOOTH device that is

connecting with the speaker, there may be distorted sound or noise in the speaker output. In this case, terminate the BLUETOOTH connection

between the BLUETOOTH device and other BLUETOOTH device(s).

When using the Speaker Add function, the aptX and LDAC codecs cannot be used. These codecs will automatically be converted to AAC or SBC.

Note

If you want to reset one of the speakers while using the Speaker Add function, be sure to cancel the Speaker Add function. If you do not cancel

the Speaker Add function before resetting a speaker, malfunctions will occur, such as weak BLUETOOTH connections and choppy sound.

You cannot listen to music from an external device connected to the AUDIO IN jack while using two speakers.