Page 1
Installation and Operations Guide Model: 810 Commercial Water System LifeSource Water Systems, Inc. 523 S. Fair Oaks Ave. Pasadena, CA 91105 LifeSourceWater.com Customer Service: (626) 792-9996 CA Lic. #787179 - NV Lic. #059578...
Equipment Specifications 810 Commercial Water System Overview Water Filter Specifications The 810 Commercial Water Filter is a no maintenance, whole facility water ltration system. This system includes a fully automatic valve head that runs a self-rinsing cycle every 14-days. 1” •...
All installations are to be done in accordance with any local codes. LifeSource Water Systems are attached to the main water line going into the building. The pipe connection is made after the pressure regulator, if present, and after the sprinkler supply line.
Page 4
Installation 810 Commercial System Installation Instructions and Setup Water Filter System Location Requirements Place this system vertically on a smooth, level surface. This system operates in an UP-Flow, fluidized bed mode. Level surface is required. The system may be placed in any position during shipping and installation but must be operated in the vertical position.
Installation 810 Commercial System Installation Instructions and Setup Water Filter Installation Instructions Continued... 8. Connecting The Rinse Line The rinse line can be directed to a ground location that has sufficient percolation, a driveway or a drain. In areas where freezing occurs, the rinse line cannot be directed or located outdoors.
Page 6
Manual Rinse Manual Rinse Instructions Of Newly Installed Filter First Rinse Of Newly Installed System After installing a new filter, it is extremely important that the system be throughly rinsed manually to remove the dust and carbon fines on the new carbon. NOTE: If the tank has been pre-filled with water, extreme care must be taken in the initial filling.
Setting Timer How To Set Or Reset System Self-Cleaning Timer Manual Rinse Cycle Instructions Continued... 8. After the Manual Rinse Cycle has been completed, rotate the valve control lever to the SERVICE position. Make sure the control lever is in the full SERVICE position. [See Figure 8] NOTE: This system is equipped with a timer to automatically rinse and clean the system on a regular basis, so manually rinsing the system will not be necessary in the future.
Page 8
2. One month after your LifeSource system installation, drain the hot water heater until the drained water runs clear. In addition your hot water heater should be drained once a year per manufacturer’s instructions. Older water heaters may descale with LifeSource water and should be drained one month or so (as scale dislodges).
Washing Machines Clean water from your LifeSource System cleans better. For best results reduce soap usage by about 75%. Do not use single dose detergent packs or pods. Packs or pods will overwhelm your washing machine and clothes with excess soap. Excess soap will remain in clothes after rinse cycle.
LIMITED 5 YEAR WARRANTY To the original owner, at the original installation site, the LifeSource Water Systems tank and internal components are warranted not to leak, burst or fail in any way, for a period of five years from the installation date, subject to the following conditions: 1.
Page 11
Defective parts are subject to inspection by either LifeSource Water Systems, Inc. or any authorized representative before final commitment of warranty adjustment is made. LifeSource Water, Systems Inc. reserves the right to make changes or substitutions in parts or equipment with material of equal quality or value.