Sony 3-299-270-21(2) Operating Instructions Manual page 25

Before performing the Auto
Calibration
Before you perform the Auto Calibration, set up
and connect the speakers (page 15).
• The ECM-AC2 jack is used for the calibration
mic (supplied) only. Do not connect other
microphones to this jack. Doing so may
damage the subwoofer and the calibration mic.
• During the calibration, the sound that comes
out of the speakers is very loud. Pay attention
to the presence of children or to the effect on
your neighborhood.
• Perform the Auto Calibration in a quiet
environment to avoid the effect of noise and to
get a more accurate measurement.
• If there are any obstacles in the path between
the calibration mic and the speakers, the
calibration cannot be performed correctly.
Remove any obstacles from the measurement
area to avoid measurement error.
Notes
• If the muting function is on when you perform the
Auto Calibration, it will turn off automatically.
• When you use the S-AIR product, disconnect the
headphones.
Bottom of the subwoofer
BD IN DVD IN SAT IN
IR REMOTE ANTENNA
FM
75
IR IN IR OUT1 IR OUT2
COAXIAL
DMPORT ECM-AC2 IR-R100
OPTICAL
DC 5V
0.7A MAX
TV IN DVD IN
EZW-T100 DIGITAL
SPEAKER
CENTER
To ECM-AC2 jack
1
Connect the calibration mic (supplied)
to the ECM-AC2 jack on the subwoofer.
2
Set up the calibration mic.
Place the calibration mic at your listening
position. You can also use a stool or tripod
so that the calibration mic remains at the
same height as your ears.
Tip
• The front of each speaker should face the calibration
mic. You will get a more accurate measurement.
VIDEO
TV OUT MONITOR
HDMI DVD IN SAT IN
VIDEO IN
OUT
AM
Y
P /
B
L
ASSIGNABLE
C
B
COAXIAL
P /
R
R
C
R
SAT IN SAT IN AUDIO IN
ASSIGNABLE
COMPONENT VIDEO
ONLY FOR SS-IS15
FRONT R FRONT L SUR R SUR L
Calibration mic
continued continued
25
GB