Thermal Cutout (Tco's); Oven Thermal Cutout(Flame Sensor); Replacement Of Flame Sensor - Kenmore 401.85052010 Service Manual

6. Alignment and Adjustments

6-8 Thermal Cutout (TCO'S)

There are 4 different thermal cutouts in this unit with 4 different purposes . They are :
1. Oven thermal cutout (flame sensor), on cavity top.
2. Hood thermal cutout, inside control area on duct .
3. Bottom thermal cutout, on floor of control area.
4. Magnetron thermal cutout, on magnetron .

6-8-1 Oven Thermal Cutout(Flame sensor)

The oven thermal cutout(Cavity TCO) is located on
the top side of the oven cavity beside exhaust duct
with a temperature rating of 248°F(120°C) and is non-
resetable . The cutout is tightly held to the top of the
oven cavity under the duct-upper .

6-8-2 Replacement of Flame Sensor

Disconnect oven power . Remove Grill & Panel-outer .
1. Disconnect two wire leads .
2. Slide the top of the thermal cutout and pull out it
26