Satellite Receiver And Cable/Antenna - Sony WEGA KLV S15G10 Operating Instructions Manual

Satellite Receiver
and Cable/Antenna
z If you connect the
Digital Satellite
Receiver with
component video
cables, see page 23.
KLV-S15G10
Satellite Receiver
This scenario shows a SAT Box connected through the video inputs and the
Cable/Antenna connected through the VHF/UHF input. Satellite signals are
selected by the SAT Box through the video inputs while TV signal is
selected by the TV tuner.
To connect a satellite receiver
1
Connect the satellite antenna cable to the satellite receiver's satellite
input jack.
2
Use A/V and S VIDEO cables to connect the satellite receiver's AUDIO
and S VIDEO output jacks to the TV's AUDIO and S VIDEO input
jacks (VIDEO 1 IN).
3
Connect the supplied 75-ohm coaxial cable from the antenna to the
TV's VHF/UHF input jack.
4
Run the Initial Setup program, as described in "Setting Up the Channel
List" on page 31.
If your satellite receiver is not equipped with S VIDEO, use a
VIDEO cable (yellow) instead of the S VIDEO cable.
Satellite antenna
cable
Rear of TV
VIDEO 3 IN (480p/480i)
P
R
P R
B
Y AUDIO L
S VIDEO cable
S VIDEO
A/V cable
VIDEO 1 IN AUDIO OUT
R
AUDIO
L R
S VIDEO
(MONO)
L
VIDEO
AUDIO-R (red)
AUDIO-L (white)
VIDEO (yellow)
Connecting the TV
VHF/UHF
75-ohm coaxial
cable
21
(Continued)