Sony WEGA KLV-26HG2 Operating Instructions Manual page 44

42
Menu System
C)
Normally the automatic fine tuning (AFT) option will give the best possible picture,
however you can manually fine-tune the TV to obtain a better picture if the picture
is distorted.
To do this:
1
Press PROG +/– to select the programme number with the channel you want to fine-
tune manually.
You cannot select the programme number set to skip in the "Skip" option
(see step D on page 42).
2 When the programme you want to fine-tune appears on the screen, select the AFT
option and press .
3
Press or to adjust the fine tuning between –15 and +15 and press OK.
4 Highlight the Confirm option and press OK. Then press
finally press OK to store your choice.
To restore automatic fine tuning, select On in step 3 above.
D)
Skip any unwanted programme numbers when they are selected with the
PROG +/– buttons.
To do this:
1 Highlight the Programme option and press
programme number you want to skip.
2
When the programme you want to skip appears on the screen, select the Skip option
and press .
3
Press or to select Yes and press OK.
4
Highlight the Confirm option and press OK. Then press
finally press OK to store your choice.
To cancel this function afterwards, select No instead of Yes in step 3 above.
E)
View and record scrambled channels when using a decoder connected to the Scart
connector 2/ 2 either directly or via a VCR.
S
Depending on the country/region you have selected in the "Country" option, this
option may not be available (see page 39).
To do this:
1
Press PROG +/– to select the programme number with the scrambled channel you
want to view.
You cannot select the programme number set to skip in the "Skip" option
(see step D on page 42).
2 When the programme you want to view appears on the screen, select the Decoder
option and press .
3
Press or to select On and press OK.
4
Highlight the Confirm option and press OK. Then press
finally press OK to store your choice.
To cancel this function afterwards, select Off instead of On in step 3 above.
to select OK and
. Then press or to select the
to select OK and
to select OK and